EQ typical examples -3

21.customer require the copper thickness is 34um,we don’t know if it is base or finished copper.

Our suggestion : A  the base copper is 18um,finished copper ≥35um

                        B   the base copper is 35um

22.the customer require the hole size is 1.55-1.65mm, That is to say ,the hole size is 1.60+/-0.05mm.but we found that their size are 1.50mm in the “350387drl124.drl”

Our suggestion: We will follow the “350387drl124.drl”,their size are 1.50+/-0.05mm.

23.customer indicate the holes of tolerance is +/-0.0mm, their tolerance is Something impossible.

Our suggestion: Pth tolerance is +/-0.08mm, Npth tolerance is +/-0.05mm.

24.it show size is 5.100 inch in your “900-100-50067 Panel V04.gbr”,but we measure the size is 5.107inch in gerber , which shall we follow ?

Our suggestion: we will follow gerber to build

25.according your panel drawing ,the board no v-cut only need routing ,but you don't indicate the slot width in fab drawing .

Our suggestion: the slot width is 2.40mm.

26.Pls see below drawing, we think the 8 off ф25mil hole on oval pads should be made as slot holes, pls confirm.If it is, then what’s the size of it? The board is on line and we are urgent for your quickly response, TKS so much!

27.Because this board unit size is same as the p/n: V5SC104-V1.Pls confirm the panel drawing is same as the panel drawing of p/n: V5SC104-V1? ,We consider them are same and we will follow the pane drawing of P/N: V5SC104-V1 to produce. pls confirm.

28．The data of notches in Q1 differs that in gerber, one is 3.55”X3.775”and another is 75*150mil the in gerber , Pls confirm we should follow the gerber data to build or pls supply new outline

Our suggestion: Follow gerber data

29.The range of press fit holes to be 1.125mm to 1.175mm is too strict for us in Q2, the best we can do is 1.14+/-0.05mm, pls relax it. otherwise we can’t do it.

Our suggestion: Ok to relax it 1.14+/-0.05mm.

30．We can’t catch the meaning of the note 3 clearly : plate through finished hole size to be within 1.00mm to 1.09mm, because we found that these are 11 kinds of the plated through holes size in the board which is from 0.508mm to 3.81mm. pls make a explain of it or ignore it.

Our suggestion: ignore it.